SomoGear Common Questions

Find quick answers about SomoGear products, recoil rating, mounting torque, laser visibility, co-aligned lasers, night vision use, and troubleshooting guides.

SomoGear laser devices are designed for airsoft, milsim, and tactical training use. Some models are built to withstand 5.56 recoil, but users should always check the product page for specific recoil-rating details before use.

The main functions and output power are the same. The differences are mainly in the battery cap, exterior design, and activation button configuration. Please note that the Non-UHP version does not include VIS-HI mode. (means without Visible High Power)

The visible laser beam is easier to see in outdoor, humid, dusty, or foggy environments. In clean indoor air, you may only see the laser dot.

Yes. SomoGear units are shipped in sealed condition. Unsealed units are not offered as standard products.

You can find the step-by-step instructions in the official operation manual here: How to Program SomoGear PEQ-15 IR Illuminator Pulse Rate.

SomoGear products support a battery voltage range of 2.4V–4.2V. We do not recommend a specific battery brand because we cannot test every battery on the market. Please use the correct battery type listed on the product page or user manual, and buy from a reputable source to avoid counterfeit or re-wrapped batteries.

For the aiming laser mount, SomoGear recommends around 20 in-lbs / 2.3 Nm with blue Loctite. For the switch mount, SomoGear recommends around 4.5 in-lbs / 0.5 Nm.

To the naked eye, a green laser usually appears brighter than a red laser at the same power level. Under night vision devices, both may appear similar depending on the environment and device settings.

Somogear aiming laser power comprasion chart under NVG and naked eye

It depends on the version. Flashlight versions do not have co-aligned visible and IR lasers, and the offset may be about 80 cm at 30 yards..
IR illuminator versions with co-aligned VIS and IR aiming lasers are designed to keep the offset within about 10 cm at 30 yards.

SomoGear does not announce new products until they are ready to ship. Product ideas and suggestions are welcome through the contact page or by email at support@somogear.com.

Potting is typically done directly into a plastic or metal housing designed to hold a PCB. The process allows the potting compound to be properly dispensed and degassed through pouring, resulting in better protection. PCB potting services help protect electronic assemblies against physical stress, thermal shock, chemical exposure, heat, and humidity.
SomoGear PCB Potting Process